Contents
About This Document.....................................................................................................................1
1 Layer 2 Multicast Configuration.............................................................................................1-1
1.1 Introduction to Layer 2 Multicast....................................................................................................................1-2
1.2 Layer 2 Multicast Features Supported by the S9300......................................................................................1-2
1.3 Logical Relationships Between Configuration Tasks.....................................................................................1-3
1.4 Configuring Static Layer 2 Multicast..............................................................................................................1-4
1.4.1 Establishing the Configuration Task......................................................................................................1-4
1.4.2 Creating a VLAN and Enabling IGMP Snooping .................................................................................1-4
1.4.3 (Optional) Setting the Forwarding Mode of Multicast Data in a VLAN...............................................1-5
1.4.4 Adding an Interface to a VLAN.............................................................................................................1-6
1.4.5 Adding an Interface to a Multicast Group Statically..............................................................................1-6
1.4.6 Checking the Configuration...................................................................................................................1-7
1.5 Configuring Multicast VLAN Replication......................................................................................................1-7
1.5.1 Establishing the Configuration Task......................................................................................................1-7
1.5.2 Creating a Multicast VLAN...................................................................................................................1-8
1.5.3 Creating a User VLAN...........................................................................................................................1-9
1.5.4 Adding Interfaces to Corresponding VLANs.......................................................................................1-10
1.5.5 Checking the Configuration.................................................................................................................1-11
1.6 Configuring IGMP Snooping........................................................................................................................1-11
1.6.1 Establishing the Configuration Task....................................................................................................1-12
1.6.2 Enabling IGMP Snooping....................................................................................................................1-13
1.6.3 (Optional) Setting the IGMP Version..................................................................................................1-13
1.6.4 (Optional) Setting the Forwarding Mode of Multicast Data in a VLAN.............................................1-14
1.6.5 (Optional) Configuring a Static Router Interface.................................................................................1-15
1.6.6 (Optional) Disabling Dynamic Learning on Interfaces........................................................................1-16
1.6.7 (Optional) Setting Parameters of the IGMP Snooping Querier...........................................................1-17
1.6.8 (Optional) Configuring Multicast Policies...........................................................................................1-17
1.6.9 (Optional) Configuring an SSM Group Policy....................................................................................1-18
1.6.10 (Optional) Configuring Layer 2 Multicast SSM Mapping.................................................................1-19
1.6.11 (Optional) Configuring Prompt Leave for Interfaces.........................................................................1-20
1.6.12 (Optional) Configuring the S9300 to Respond to Changes of a Layer 2 Network Topology............1-21
1.6.13 (Optional) Modifying Parameters of IGMP Snooping in a VLAN....................................................1-22
1.6.14 Checking the Configuration...............................................................................................................1-24
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast Contents
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
i