Procedure
l Run the reset igmp-snooping statistics { all | vlan { vlan-id | all } } command in the user
view to clear the statistics on IGMP snooping.
----End
1.7.4 Debugging IGMP Snooping
Context
CAUTION
Debugging affects the performance of the system. So, after debugging, run the undo debugging
igmp-snooping all command to disable it immediately.
Procedure
l Run the debugging igmp-snooping { all | event | leave [ basic-acl-number ] | packet
[ advance-acl-number ] | query [ advance-acl-number ] | report [ advance-acl-number ] |
timer } command in the user view to enable debugging of IGMP snooping.
----End
1.8 Configuration examples
This section provides several configuration examples of Layer 2 multicast.
1.8.1 Example for Configuring Static Layer 2 Multicast
1.8.2 Example for Configuring Multicast VLAN Replication
1.8.3 Example for Configuring IGMP Snooping
1.8.4 Example for Configuring Layer 2 Multicast SSM Mapping
1.8.1 Example for Configuring Static Layer 2 Multicast
Networking Requirements
As shown in Figure 1-2, GE 3/0/1 of the S9300 is connected to a router, and GE 1/0/1 of the
S9300 is connected to Host 3, Host 4, and Host 5. It is required that all the hosts in VLAN 3
should receive the multicast packets from the multicast group 225.0.0.1.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 1 Layer 2 Multicast Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-27
To Next Page
Loading...
Need help?
General
