EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip rpf-route-static source-address { mask | mask-length } [ protocol [ process-
id ] ] [ route-policy policy-name ] rpf-address [ preference preference ] [ order
order-num ]
The static multicast route is configured.
l source-address { mask | mask-length }: specifies the address and mask of the multicast source.
l protocol [ process-id ]: indicates that the matched route must be contained in the specified
unicast routing protocol.protocol specifies the unicast routing protocol. process-id specifies
the process number.
l route-policy policy-name: specifies the matching rule of the static multicast route.
l rpf-address: specifies the IP address of the RPF interface.
l preference preference: specifies the route preference. A greater value of preference indicates
a higher preference.
l order order-num: specifies the sequence of configurations of routes on the same segment.
----End
6.4.3 Checking the Configuration
Prerequisite
The configuration of a static multicast route is complete.
Procedure
l Run the display multicast routing-table static [ config ] [ source-address { mask | mask-
length } ] command to check the information about the static multicast routing table.
l Run the display multicast rpf-info source-address [ group-address ] command to check
the information about RPF routes with the specified multicast source.
----End
Example
After configuring a static multicast route, run the display multicast routing-table static
command. You can view information about the multicast static route.
<Quidway> display multicast routing-table static
Multicast Routing Table
Routes : 1
Mroute 11.1.0.0/24
Interafce = Vlanif100 RPF Neighbor = 11.1.2.2
Matched routing protocol = ospf, process-id = 100, Route-policy = none
Preference = 1, Order = 1
Running Configuration = ip rpf-route-static 11.1.0.0 24 ospf 100 11.1.2.2 order 1
6 Multicast Route Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
6-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals