The system view is displayed.
2. Run:
pim
The PIM view is displayed.
3. Run:
c-bsr global [ hash-length hash-length | priority priority ]
*
The C-BSR parameters are set in the global domain.
– hash-length: specifies the hash mask length of the C-BSR.
– priority: specifies the C-BSR priority.
----End
4.9.5 Checking the Configuration
Prerequisite
The configuration of the administrative domain is complete.
Procedure
l Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check the PIM information on the interface.
l Run the display pim bsr-info command to check the BSR information in the PIM-SM
domain.
----End
Example
Run the display pim interface vlanif 15 verbose command to check the PIM information on
VLANIF 15.
<Quidway> display pim interface vlanif 15 verbose
VPN-Instance: public net
Interface: Vlanif15, 10.0.0.15
PIM version: 2
PIM mode: Sparse
PIM state: up
PIM DR: 10.0.0.15 (local)
PIM DR Priority (configured): 1
PIM neighbor count: 0
PIM hello interval: 30 s
PIM LAN delay (negotiated): 500 ms
PIM LAN delay (configured): 500 ms
PIM hello override interval (negotiated): 2500 ms
PIM hello override interval (configured): 2500 ms
PIM Silent: disabled
PIM neighbor tracking (negotiated): disabled
PIM neighbor tracking (configured): disabled
PIM generation ID: 0XE5F4034D
PIM require-GenID: disabled
PIM hello hold interval: 105 s
PIM assert hold interval: 3600 s
PIM triggered hello delay: 5 s
PIM J/P interval: 60 s
PIM J/P hold interval: 210 s
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 4 PIM-SM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-31
To Next Page
Loading...
Need help?
General
