Huawei Quidway S9300

According to the preceding information, multicast groups 225.1.1.1 to 225.1.1.3 are configured
with static forwarding entries.
# View the multicast forwarding table.
<S9300> display l2-multicast forwarding-table vlan 3
VLAN ID : 3, Forwarding Mode : IP
-----------------------------------------------------------------------
(Source, Group) Interface Out-Vlan
-----------------------------------------------------------------------
Router-port GigabitEthernet3/0/1 3
(*, 225.1.1.1) GigabitEthernet1/0/1 3
(*, 225.1.1.2) GigabitEthernet1/0/1 3
(*, 225.1.1.3) GigabitEthernet1/0/1 3
-----------------------------------------------------------------------
Total Group(s) : 3
The preceding information shows the VLAN ID and outgoing interface mapping the data from
multicast groups 225.1.1.1 to 225.1.1.3.
----End
Configuration Files
l Configuration file of the S9300
#
sysname S9300
#
vlan batch 3
#
igmp-snooping enable
#
vlan 3
igmp-snooping enable
#
interface GigabitEthernet1/0/1
port hybrid tagged vlan 3
l2-multicast static-group group-address 225.1.1.1 vlan 3
l2-multicast static-group group-address 225.1.1.2 vlan 3
l2-multicast static-group group-address 225.1.1.3 vlan 3
#
interface GigabitEthernet3/0/1
port hybrid tagged vlan 3
igmp-snooping static-router-port vlan 3
#
return
1.8.4 Example for Configuring Layer 2 Multicast SSM Mapping
Networking Requirement
As shown in Figure 1-5, GE 2/0/0 of the S9300 is connected to the upstream multicast router;
GE 1/0/1 and GE 1/0/2 are connected to user hosts. The user hosts run IGMPv2 and do not
support IGMPv3.
The range of SSM group addresses on the current network is 232.0.0.0 to 232.255.255.255.
Source 1 and Source 2 send multicast data to the multicast group 232.1.1.1. It is required that
user hosts Host 1 and Host 2 receive only the multicast data from Source 2.
To meet this requirement, you need to configure SSM mapping on the S9300 to set up a mapping
between the multicast group and the multicast source.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 1 Layer 2 Multicast Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-35