Huawei Quidway S9300 - Adding an Interface to a VLAN; Adding an Interface to a Multicast Group Statically

The multicast flows in the VLAN are forwarded based on IP addresses or MAC addresses.
By default, multicast flows are forwarded based on IP addresses.
----End
1.4.4 Adding an Interface to a VLAN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a GE interface, an Ethernet interface, or an Eth-Trunk interface.
Step 3 Run:
port hybrid tagged vlan vlan-id
The interface is added to a VLAN.
NOTE
If multicast VLAN replication is not configured, the interface of the S9300 that connects to a router and
receives the multicast packets from the router and the interface that connects to users and sends multicast
packets to users must be added to the same VLAN.
----End
1.4.5 Adding an Interface to a Multicast Group Statically
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a GE interface, an Ethernet interface, or an Eth-Trunk interface.
Step 3 Run:
l2-multicast static-group { [ source-address source-ip-address ] group-address
group-ip-address } vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> }
The interface is added to the multicast group statically.
----End
1 Layer 2 Multicast Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
1-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)