EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.8.4 Monitoring the Multicast Routing and Forwarding
6.8.5 Debugging Multicast Forwarding and Routing
6.8.1 Checking the Multicast Routes
Context
When data transmission is abnormal, you can ping related multicast addresses to check the
multicast routes.
Procedure
l Run the ping multicast -i interface-type interface-number [ -c count | -m time | -p
pattern | -q | -s packetsize | -t timeout | -tos tos-value | -v ]
*
host command to ping the
reserved group addresses.
l Run the ping multicast [ -c count | -h ttl-value | -m time | -p pattern | -q | -s packetsize | -
t timeout | -tos tos-value | -v ]
*
host command to ping the common group addresses.
----End
6.8.2 Checking the RPF Path and Multicast Path
Context
When a fault occurs during data transmission, run the following commands to check RPF paths
and multicast paths.
Procedure
l Run the mtrace [ -ur resp-dest | -l [ stat-times ] [ -st stat-int ] | -m max-ttl | -q nqueries | -
ts ttl | -tr ttl | -v | -w timeout ]
*
source source-address command to check the RPF path
from a multicast source to the device of a querier.
l Run the mtrace -g group [ { -mr | -ur resp-dest } | -l [ stat-times ] [ -st stat-int ] | -m max-
ttl | -q nqueries | -ts ttl | -tr ttl | -v | -w timeout ]
*
source source-address command to check
the multicast path from a multicast source to the device of a querier.
l Run the mtrace [ -gw last-hop-router | -d ] -r receiver [ -ur resp-dest | -a source-ip-
address | -l [ stat-times ] [ -st stat-int ] | -m max-ttl | -q nqueries | -ts ttl | -tr ttl | -v | -w
timeout ]
*
source source-address command to check the RPF path from a multicast source
to a destination host.
l Run the mtrace [ -gw last-hop-router | -b | -d ] -r receiver -g group [ { -mr | -ur resp-
dest } | -a source-ip-address | -l [ stat-times ] [ -st stat-int ] | -m max-ttl | -q nqueries | -ts
ttl | -tr ttl | -v | -w timeout ]
*
source source-address command to check the multicast path
from a multicast source to a destination host.
6 Multicast Route Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
6-14 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals