Example
Run the display igmp interface vlanif 3 command to check the configuration of IGMP on
VLANIF 3.
<Quidway> display igmp interface vlanif 3
Vlanif3 (100.0.0.3):
IGMP is enabled
Current IGMP version is 2
IGMP state: up
IGMP group policy: 2005
Value of query interval for IGMP (negotiated): -
Value of query interval for IGMP (configured): 60 s
Value of other querier timeout for IGMP: -
Value of maximum query response time for IGMP: 10 s
Querier for IGMP: 100.0.0.3 (this router)
Run the display igmp group static command to check the information about the static IGMP
multicast group.
<Quidway> display igmp group static
Static join group information of VPN-Instance: public net
Total 2 entries
Group Address Source Address Interface Expires
225.0.0.10 0.0.0.0 Loop1 never
225.0.0.20 10.0.0.1 Vlanif3 never
2.5 Setting the Parameters of IGMP Features
This section describes how to set the parameters of IGMP features.
Context
By default, IGMP can work normally. In the S9300, you can change the values of related
parameters according to the specific network environment. You can perform the following
configurations as required.
NOTE
l The configuration in the IGMP view is valid globally. The configuration in the interface view is valid
only for the specific interface.
l If this command is configured in the interface view and the IGMP view, the values set in the interface
view are preferred. If this command is not configured in the interface view, the values configured in
the IGMP view are valid.
2.5.1 Establishing the Configuration Task
2.5.2 Configuring IGMP Message Options
2.5.3 Configuring the IGMPv1 Querier
2.5.4 Configuring the IGMPv2 or IGMPv3 Querier
2.5.5 Configuring IGMP Prompt Leave
2.5.6 Checking the Configuration
2.5.1 Establishing the Configuration Task
2 IGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
2-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)
To Next Page
Loading...
Need help?
General
