EasyManuals Logo

Huawei Quidway S9300 Configuration Guide - Multicast

Huawei Quidway S9300
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #162 background imageLoading...
Page #162 background image
By default, the interval for checking the transmission rate of multicast packets is 15 seconds.
Step 4 Run:
spt-switch-threshold { traffic-rate | infinity } [ group-policy basic-acl-number
[ order order-value ] ]
The condition of the SPT switchover is set.
l traffic-rate: specifies the rate threshold of the SPT switchover.
l infinity: indicates that the SPT switchover is not triggered.
l group-policy basic-acl-number [ order order-value ]: is used to set the range of the multicast
groups that use this threshold. By default, the threshold is applicable to all multicast groups.
----End
4.12.3 Checking the Configuration
Prerequisite
The setting of the parameters for controlling the SPT switchover is complete.
Procedure
l Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check the PIM information on the interface.
----End
Example
Run the display pim interface vlanif 15 verbose command, and you can view the PIM
information on VLANIF 15.
<Quidway> display pim interface vlanif 15 verbose
VPN-Instance: public net
Interface: Vlanif15, 10.0.0.15
PIM version: 2
PIM mode: Sparse
PIM state: up
PIM DR: 10.0.0.15 (local)
PIM DR Priority (configured): 1
PIM neighbor count: 0
PIM hello interval: 30 s
PIM LAN delay (negotiated): 1800 ms
PIM LAN delay (configured): 1800 ms
PIM hello override interval (negotiated): 60000 ms
PIM hello override interval (configured): 60000 ms
PIM Silent: disabled
PIM neighbor tracking (negotiated): enabled
PIM neighbor tracking (configured): enabled
PIM generation ID: 0XE5F4034D
PIM require-GenID: disabled
PIM hello hold interval: 36000 s
PIM assert hold interval: 360 s
PIM triggered hello delay: 5 s
PIM J/P interval: 60 s
PIM J/P hold interval: 210 s
PIM state-refresh capability on link: non-capable
PIM BSR domain border: enabled
PIM BFD: disabled
PIM dr-switch-delay timer : not configured
4 PIM-SM Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
4-42 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)

Table of Contents

Other manuals for Huawei Quidway S9300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S9300 and is the answer not in the manual?

Huawei Quidway S9300 Specifications

General IconGeneral
BrandHuawei
ModelQuidway S9300
CategoryNetwork Router
LanguageEnglish

Related product manuals