Huawei Quidway S9300

Context
Do as follows on all the S9300s on the multicast source side.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
register-suppression-timeout interval
The timeout period for keeping the register suppression is set.
Step 4 Run:
probe-interval interval
The interval for sending null Register messages is set.
The value of probe-interval must be less than half of register-suppression-timeout.
----End
4.6.4 Checking the Configuration
Prerequisite
The setting of the parameters for controlling source registering is complete.
Procedure
l Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check the PIM information on the interface.
----End
Example
Run the display pim interface vlanif 15 verbose command, and you can view the PIM
information on VLANIF 15.
<Quidway> display pim interface vlanif 15 verbose
VPN-Instance: public net
Interface: Vlanif15, 10.0.0.15
PIM version: 2
PIM mode: Sparse
PIM state: up
PIM DR: 10.0.0.15 (local)
PIM DR Priority (configured): 1
PIM neighbor count: 0
PIM hello interval: 30 s
PIM LAN delay (negotiated): 500 ms
PIM LAN delay (configured): 500 ms
4 PIM-SM Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
4-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)