<Quidway> display pim rp-info
VPN-Instance: public net
PIM SM static RP information:
Static RP: 10.0.0.15 (local)
In the case of a dynamic RP, the configuration is as follows:
<Quidway> display pim rp-info
VPN-Instance: public net
PIM-SM BSR RP information:
Group/MaskLen: 224.0.0.0/4
RP: 10.0.0.15 (local)
Priority: 0
Uptime: 00:00:10
Expires: 00:02:20
Run the display pim bsr-info command to check the BSR information.
<Quidway> display pim bsr-info
VPN-Instance: public net
Elected AdminScoped BSR Count: 0
Elected BSR Address: 10.0.1.20
Priority: 0
Hash mask length: 30
State: Elected
Scope: Not scoped
Uptime: 00:00:27
Next BSR message scheduled at: 00:00:33
C-RP Count: 1
Candidate AdminScoped BSR Count: 0
Candidate BSR Address: 10.0.1.20
Priority: 0
Hash mask length: 30
State: Elected
Scope: Not scoped
Wait to be BSR: 0
4.5 Setting the Parameters for Controlling a Multicast
Source
This section describes how to control the forwarding of multicast data according to the multicast
source on the PIM network.
4.5.1 Establishing the Configuration Task
4.5.2 Setting the Keepalive Period of a Multicast Source
4.5.3 Configuring the Rules for Filtering Multicast Source Addresses
4.5.4 Checking the Configuration
4.5.1 Establishing the Configuration Task
Applicable Environment
An S9300 that runs PIM checks the received multicast data. By checking whether the data meets
the filtering rule, the S9300 determines whether to forward the multicast data. That is, the
S9300 functions as a filter of multicast data. The filter controls data traffic and limits information
obtained by downstream receivers. Therefore, the security of the data is improved.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 4 PIM-SM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-11
To Next Page
Loading...
