3 PIM-DM Configuration
About This Chapter
This chapter describes the procedure for configuring PIM-DM on the IP network and the
commands for maintaining PIM-DM, and provides configuration examples.
3.1 Introduction to PIM-DM
This section describes the basic information about PIM-DM.
3.2 PIM-DM Features Supported by the S9300
This section describes PIM-DM features supported by the S9300.
3.3 Logical Relationships Between Configuration Tasks
This section describes the logical relationships between the configuration tasks.
3.4 Configuring Basic PIM-DM Functions
This section describes the applications of PIM-DM and method of configuring PIM-DM.
3.5 Setting the Parameters for Controlling a Multicast Source
This section describes how to control the multicast data forwarding of a multicast source on the
PIM network.
3.6 Setting the Neighbor Control Parameters
This section describes how to set control parameters of the PIM-DM Hello message.
3.7 Setting the Forwarding Control Parameters
This section describes how to set the parameters for controlling Join messages or Prune messages
of PIM-DM.
3.8 Setting the Parameters of State-Refresh Messages
This section describes how to set the parameters of PIM-DM State-Refresh messages.
3.9 Setting the Graft Control Parameters
This section describes how to set control parameters of the PIM-DM Graft messages.
3.10 Setting the Assert Control Parameters
This section describes how to set control parameters of the PIM-DM Assert messages.
3.11 Configuring PIM Silent
This section describes how to configure PIM silent to protect hosts against attacks.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 3 PIM-DM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-1
To Next Page
Loading...
