5.5.3 Setting the Interval for Retrying Setting Up the TCP
Connection Between MSDP Peers
Context
Do as follows on the S9300 where the MSDP peer is created.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
msdp
The MSDP view is displayed.
Step 3 Run:
timer retry interval
The interval for sending TCP connection requests to the remote MSDP peer is set.
----End
5.5.4 Controlling Status of the MSDP Peer Connection
Context
Do as follows on the S9300 where an MSDP peer is configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
msdp
The MSDP view is displayed.
Step 3 Run:
shutdown peer-address
The session between the S9300 and the remote MSDP peer is closed.
l The peer-address parameter specifies the address of the remote MSDP peer.
l After the session between the S9300 and the remote MSDP peer is closed, the TCP connection
is torn down. SA messages are not exchanged between the MSDP peers and the connection
is not set up any more. The configuration, however, is saved.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 5 MSDP Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-11
To Next Page
Loading...
