Huawei Quidway S9300

3. Run:
port hybrid tagged vlan vlan-id
The interface is added to a multicast VLAN.
The vlan-id parameter specifies the ID of a multicast VLAN.
----End
1.5.5 Checking the Configuration
Prerequisite
The configuration of multicast VLAN replication is complete.
Procedure
l Run the display multicast-vlan vlan [ vlan-id ] command to check information about a
multicast VLAN.
l Run the display user-vlan vlan [ vlan-id ] command to check information about a user
VLAN.
----End
Example
Run the display multicast-vlan, and you can view information about a multicast VLAN. The
following is an example:
<Quidway> display multicast-vlan vlan 7
Multicast-vlan : 7
User-vlan : 2
IGMP snooping state : Enable
User-vlan Snooping-state
-------------------------------------
8 Enable
9 Enable
Run the display user-vlan, and you can view information about a user VLAN. The following
is an example:
<Quidway> display user-vlan vlan 8
user-vlan snooping-state q-flag q-addr multicast-vlan
--------------------------------------------------------------------
8 Enable -- ---- 7
1.6 Configuring IGMP Snooping
This section describes how to configure IGMP snooping in a VLAN.
1.6.1 Establishing the Configuration Task
1.6.2 Enabling IGMP Snooping
1.6.3 (Optional) Setting the IGMP Version
1.6.4 (Optional) Setting the Forwarding Mode of Multicast Data in a VLAN
1.6.5 (Optional) Configuring a Static Router Interface
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 1 Layer 2 Multicast Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-11