Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast routing-enable
IP multicast routing is enabled.
By default, the IP multicast routing function is disabled on an S9300
----End
2.4.3 Enabling the IGMP Function
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
An S9300 uses this interface to communicate with hosts. The vlan-id variable specifies the ID
of a VLAN. The ID of a VLANIF interface must match an existing VLAN.
Step 3 Run:
igmp enable
The IGMP function is enabled.
By default, the IGMP function is disabled on an interface.
----End
2.4.4 (Optional) Specifying the IGMP Version
Context
CAUTION
Make sure that all the interfaces on S9300s are configured with IGMP of the same version on
one network segment. By default, IGMPv2 is adopted.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 2 IGMP Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-5
To Next Page
Loading...
