Huawei Quidway S9300

6.5.2 Configuring the Longest-Match Principle for Selecting
Multicast Routes
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast longest-match
The S9300 is configured to select multicast routes by using the longest-match principle.
By default, the S9300 selects routes according to the sequence of entries.
----End
6.5.3 Configuring Multicast Load Balancing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast load-splitting { source | group | source-group }
The load is balanced between routes based on multicast sources and multicast groups.
l group: specifies load balancing based on multicast groups.
l group: specifies load balancing based on multicast sources.
l group: specifies load balancing based on multicast sources and groups.
By default, load balancing is not performed.
----End
6.5.4 Checking the Configuration
Prerequisite
The configuration of the multicast routing policy is complete.
Procedure
l Run the display multicast routing-table [ group-address [ mask { group-mask | group-
mask-length } ] ] [ source-address [ mask { source-mask | source-mask-length } ] ]
[ incoming-interface { interface-type interface-number | register } ] [ outgoing-
6 Multicast Route Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
6-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)