No. Data
1 Address of the multicast forwarding
boundary
6.6.2 Configuring the Multicast Forwarding Boundary
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
On an S9300, only the VLANIF and loopback interfaces can be configured with the multicast
forwarding boundary.
Step 3 Run:
multicast boundary group-address { mask | mask-length }
The multicast forwarding boundary is configured.
By default, the multicast forwarding boundary is not set on an interface.
----End
6.6.3 Checking the Configuration
Prerequisite
The configuration of the multicast forwarding range is complete.
Procedure
l Run the display multicast routing-table [ group-address [ mask { group-mask | group-
mask-length } ] ] [ source-address [ mask { source-mask | source-mask-length } ] ]
[ incoming-interface { interface-type interface-number | register } ] [ outgoing-
interface { include | exclude | match } { interface-type interface-number | register |
none } ] command to check the information about the multicast routing table.
l Run the display multicast boundary [ group-address [ mask | mask-length ] ]
[ interface vlanif vlan-id ] command to check the information about the multicast boundary
of the interface.
----End
6 Multicast Route Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
6-10 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)
To Next Page
Loading...
