6 Multicast Route Management
About This Chapter
This chapter describes the principle of RPF, procedures for configuring multicast static routes
and forwarding policies, and commands for maintaining multicast static routes and forwarding
policies, and provides configuration examples.
6.1 Introduction to Multicast Route Management
This section describes the principle and concepts of multicast routing, forwarding, and RPF.
6.2 Multicast Route Management Features Supported by the S9300
This section describes multicast route management features supported by the S9300.
6.3 Logical Relationships Between Configuration Tasks
This section describes the logical relationships between the configuration tasks.
6.4 Configuring a Static Multicast Route
This section describes the applications of the static multicast route and method of configuring
a static multicast route.
6.5 Configuring a Multicast Routing Policy
This section describes how to configure a multicast routing policy.
6.6 Configuring the Multicast Forwarding Range
This section describes how to configure the multicast forwarding range.
6.7 Setting the Parameters for Controlling the Multicast Forwarding Table
This section describes the parameters used to control the multicast forwarding table and how to
set these parameters.
6.8 Maintaining Multicast Routes
This section describes how to clear the statistics on multicast routing and forwarding, and debug
multicast routing and forwarding.
6.9 Configuration Examples
This section provides several examples of static route configuration.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 6 Multicast Route Management
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-1
To Next Page
Loading...
