The interface is configured as a static router interface.
----End
1.6.6 (Optional) Disabling Dynamic Learning on Interfaces
Context
To control the multicast packets received by hosts, you can disable dynamic learning on
interfaces. After the dynamic learning function is disabled on interfaces, you can only configure
the static router interface and forwarding entries manually.
l After dynamic learning of router interfaces is disabled, you can only configure static router
interfaces manually.
l After dynamic learning is disabled on multicast member interfaces, you can only add
interfaces to a multicast group manually.
Procedure
l Disabling dynamic learning of router interfaces in a VLAN
1. Run:
system-view
The system view is displayed.
2. Run:
vlan vlan-id
The VLAN view is displayed.
3. Run:
undo igmp-snooping router-learning
Dynamic learning of router interfaces is disabled in the VLAN.
By default, a router interface can be dynamically learned.
l Disabling an interface from learning forwarding entries dynamically
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a GE interface, an Ethernet interface, or an Eth-Trunk interface.
3. Run:
undo igmp-snooping learning vlan vlan-id
The interface is disabled from dynamically learning forwarding entries.
By default, an interface is enabled to dynamically learn forwarding entries.
----End
1 Layer 2 Multicast Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
1-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)
To Next Page
Loading...
