Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
source-policy acl-number
The S9300 is set to forward only the multicast packets with the source addresses that pass the
filtering.
A filter closer to the multicast source filters packets more effectively.
----End
3.5.4 Checking the Configuration
Prerequisite
The configuration of basic PIM-DM functions and the setting of the parameters for controlling
a multicast source are complete.
Procedure
l Run the display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] ] [ source-address [ mask { source-mask-length | source-mask } ] ] [ incoming-
interface { interface-type interface-number | register } ] [ outgoing-interface { include |
exclude | match } { interface-type interface-number | register | none } ] [ mode { dm |
sm | ssm } ] [ flags flag-value ] [ fsm ] command to check the PIM multicast routing table.
----End
3.6 Setting the Neighbor Control Parameters
This section describes how to set control parameters of the PIM-DM Hello message.
3.6.1 Establishing the Configuration Task
3.6.2 Setting the PIM Neighbor Control Parameters
3.6.3 Configuring the S9300 not to Receive Hello Messages Without the Generation ID
3.6.4 Checking the Configuration
3.6.1 Establishing the Configuration Task
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 3 PIM-DM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-9
To Next Page
Loading...
