EasyManuals Logo

Huawei Quidway S9300 Configuration Guide - Multicast

Huawei Quidway S9300
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
IGMP Filter Group-Policy is Set to default : Permit All
IGMP Prompt Leave Disable
IGMP Router Alert is Not Required
IGMP Send Router Alert Enable
IGMP Report Suppress Disable
IGMP Suppress Time is set to default 10 seconds
IGMP Router Port Learning Enable
IGMP Querier Disable
IGMP SSM-Mapping Disable
When the dynamic interface learning is disabled, if you run the display igmp-snooping port-
info [ vlan vlan-id ] [ group-address group-address ] [ verbose ] command, only the static
entries are displayed. If you run the display igmp-snooping router-port vlan vlan-id command,
only the static router interfaces are displayed. The following is an example.
<Quidway> display igmp-snooping port-info vlan 3
-----------------------------------------------------------------------
(Source, Group) Port Flag
-----------------------------------------------------------------------
(1.1.1.1,225.1.1.1) GE1/0/4
S--
1 port(s)
(1.1.1.1,225.1.1.2) GE1/0/4 S--
1 port(s)
(1.1.1.1,225.1.1.3) GE1/0/4 S--
1 port(s)
<Quidway> display igmp-snooping router-port vlan 3
Port Name UpTime Expires Flags
--------------------------------------------------------------
VLAN 3, 2 router-port(s)
GE2/0/1 1d:22h 00:01:20 DYNAMIC
GE2/0/3 2d:10h -- STATIC
Run the display igmp-snooping querier vlan [ vlan-id ] command. If the querier is displayed
as Enabled, it indicates that the querier is successfully enabled.
<Quidway> display igmp-snooping querier vlan
VLAN Querier-state
-----------------------------------------------
3 Enable
1.7 Maintaining Layer 2 Multicast
This section describes how to clear the static entries in a multicast forwarding table.
1.7.1 Clearing Static Entries in a Multicast Forwarding Table
1.7.2 Clearing Multicast Forwarding Entries
1.7.3 Clearing the Statistics on IGMP Snooping
1.7.4 Debugging IGMP Snooping
1.7.1 Clearing Static Entries in a Multicast Forwarding Table
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 1 Layer 2 Multicast Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-25

Table of Contents

Other manuals for Huawei Quidway S9300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S9300 and is the answer not in the manual?

Huawei Quidway S9300 Specifications

General IconGeneral
BrandHuawei
ModelQuidway S9300
CategoryNetwork Router
LanguageEnglish

Related product manuals