Huawei Quidway S9300

port hybrid tagged vlan 400
#
interface LoopBack0
ip address 3.3.3.3 255.255.255.255
pim sm
#
ospf 1
area 0.0.0.0
network 192.168.4.0 0.0.0.255
network 192.168.5.0 0.0.0.255
network 3.3.3.3 0.0.0.0
#
pim
c-bsr LoopBack0
c-rp LoopBack0
#
msdp
peer 192.168.4.1 connect-interface vlanif400
#
return
l Configuration file of S9300-F
#
sysname S9300-F
#
vlan batch 103 500
#
multicast routing-enable
#
interface vlanif 103
ip address 10.110.3.1 255.255.255.0
pim sm
#
interface vlanif 500
ip address 192.168.5.2 255.255.255.0
pim sm
#
interface GigabitEthernet1/0/0
port hybrid untagged vlan 103
#
interface GigabitEthernet2/0/0
port hybrid tagged vlan 500
#
ospf 1
area 0.0.0.0
network 192.168.5.0 0.0.0.255
network 10.110.3.0 0.0.0.255
#
return
5.9.2 Example for Configuring Inter-AS Multicast by Using Static
RPF Peers
Networking Requirements
As shown in Figure 5-2, two ASs exist on the network. Each AS contains one or more PIM-SM
domains; each PIM-SM domain has 0 or 1 multicast source and receiver. MSDP peers need to
be set up between PIM-SM domains to share the information of the multicast source.
5 MSDP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
5-34 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)