l Configuring basic multicast functions
Data Preparation
To set the parameters for controlling the multicast routing policy, you need the following data.
No. Data
1 Addresses, masks (or mask lengths) of the
multicast source and multicast group
2 Matching policy, sequence, and preference of
multicast routes
3 Maximum number of routes in the multicast
forwarding table
4 Maximum number of downstream nodes of
each routing entity in the multicast
forwarding table
6.7.2 Setting the Maximum Number of Entities in the Multicast
Forwarding Table
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast forwarding-table route-limit limit
The maximum number of entities in the multicast forwarding table is set.
By default, the maximum number of entities in the multicast forwarding table is 4096.
----End
6.7.3 Setting the Maximum Number of Downstream Nodes of a
Multicast Forwarding Entity
6 Multicast Route Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
6-12 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)
To Next Page
Loading...
