Example
Run the display multicast boundary command, and you can view information about the
multicast boundary.
<Quidway> display multicast boundary
Multicast boundary information of VPN-Instance: public net
Total 1 Multicast IPv4 boundary
Interface Boundary
Vlanif10 225.0.0.0/24
6.7 Setting the Parameters for Controlling the Multicast
Forwarding Table
This section describes the parameters used to control the multicast forwarding table and how to
set these parameters.
6.7.1 Establishing the Configuration Task
6.7.2 Setting the Maximum Number of Entities in the Multicast Forwarding Table
6.7.3 Setting the Maximum Number of Downstream Nodes of a Multicast Forwarding Entity
6.7.4 Checking the Configuration
6.7.1 Establishing the Configuration Task
Applicable Environment
When planning a specific network according to network services, perform the following
configuration policies:
l Limiting the number of entries in the IP multicast forwarding table
The S9300 creates and maintains a forwarding entry for each received multicast packet.
Excessive multicast forwarding entries, however, may use up the memory of the S9300.
You can set the maximum number of entries in the multicast forwarding table on the
S9300. Limiting the number of entries according to the actual networking and service
performance can avoid faults caused by excessive entries.
l Limiting the number of downstream nodes of a single forwarding entry
An S9300 replicates a multicast packet for each downstream node and sends it out. Each
downstream node is a branch of a multicast distribution tree. The number of downstream
nodes determines the maximum scale of an MDT and the service range. You can define
the number of downstream nodes of a single forwarding entry on the S9300. Limiting the
number of downstream nodes according to the actual networking and service performance
can ease the processing pressure of the system and control the service range.
Pre-configuration Tasks
Before setting the parameters for controlling the multicast routing policy, complete the following
tasks:
l Configuring the unicast routing protocol to ensure that IP routes between nodes are
reachable
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 6 Multicast Route Management
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-11
To Next Page
Loading...
