5 MSDP Configuration
About This Chapter
This chapter describes the procedure for configuring MSDP and commands for maintaining
MSDP, and provides configuration examples.
5.1 Introduction to MSDP
This section describes the basic information about MSDP.
5.2 MSDP Features Supported by the S9300
This section describes MSDP features supported by the S9300.
5.3 Logical Relationships Between Configuration Tasks
This section describes the logical relationships between the configuration tasks.
5.4 Configuring Basic MSDP Functions
This section describes how to configure the MSDP peer and enable the PIM-SM inter-domain
multicast.
5.5 Setting the Parameters for Controlling the MSDP Connection
This section describes how to set the description of MSDP peers and control sessions between
MSDP peers.
5.6 Configuring an Anycast RP in a PIM-SM Domain
This section describes the application scenario of the anycast RP and the method of configuring
the anycast RP.
5.7 Setting the Parameters of the SA Message
This section describes how to set the parameters of the SA message.
5.8 Maintaining MSDP
This section describes how to clear the statistics on MSDP, how to reset the MSDP peer relation,
and how to debug MSDP.
5.9 Configuration Examples
This section provides several configuration examples of MSDP.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 5 MSDP Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-1
To Next Page
Loading...
