l Run the display pim grafts command to check the PIM-DM Graft messages that are not
acknowledged.
l Run the display pim control-message counters [ interface interface-type interface-
number ] [ message-type message-type ] command to check the number of sent and
received PIM control messages.
l Run the display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] ] [ source-address [ mask { source-mask-length | source-mask } ] ] [ incoming-
interface { interface-type interface-number | register } ] [ outgoing-interface { include |
exclude | match } { interface-type interface-number | register | none } ] [ mode { dm |
sm | ssm } ] [ flags flag-value ] [ fsm ] command to check the PIM multicast routing table.
----End
Example
Run the display pim interface vlanif 15 verbose command to check the detailed PIM
information on VLANIF 15.
<Quidway> display pim interface vlanif 15 verbose
VPN-Instance: public net
Interface: Vlanif15, 10.0.0.15
PIM version: 2
PIM mode: Dense
PIM state: up
PIM DR: 10.0.0.15 (local)
PIM DR Priority (configured): 1
PIM neighbor count: 0
PIM hello interval: 30 s
PIM LAN delay (negotiated): 500 ms
PIM LAN delay (configured): 500 ms
PIM hello override interval (negotiated): 2500 ms
PIM hello override interval (configured): 2500 ms
PIM Silent: disabled
PIM neighbor tracking (negotiated): disabled
PIM neighbor tracking (configured): disabled
PIM generation ID: 0X57222616
PIM require-GenID: disabled
PIM hello hold interval: 105 s
PIM assert hold interval: 3600 s
PIM triggered hello delay: 5 s
PIM J/P interval: 60 s
PIM J/P hold interval: 210 s
PIM state-refresh processing: enabled
PIM state-refresh interval: 10 s
PIM graft retry interval: 60 s
PIM state-refresh capability on link: capable
PIM BFD: disabled
PIM dr-switch-delay timer : not configured
Number of routers on link not using DR priority: 0
Number of routers on link not using LAN delay: 0
Number of routers on link not using neighbor tracking: 1
According to the preceding information, the Graft control parameter on VLANIF 15 is 60
seconds.
Run the display pim control-message counters interface vlanif vlan-id command, and you
can view information about PIM control messages on a specified interface.
<Quidway> display pim control-message counters interface vlanif 15
VPN-Instance: public net
PIM control-message counters for interface: Vlanif15
Received Sent Invalid
Assert 0 0 0
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 3 PIM-DM Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-23
To Next Page
Loading...
