Context
PIM silent protects S9300s against PIM Hello message attacks.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
On the S9300, VLANIF interfaces and loopback interfaces support PIM.
Step 3 Run:
pim silent
PIM silent is enabled.
NOTE
The PIM silent and PIM BFD functions cannot be enabled at the same time.
----End
3.11.3 Checking the Configuration
Prerequisite
The configuration of PIM silent is complete.
Procedure
l Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check the PIM information on the interface.
----End
Example
Run the display pim interface vlanif 15 verbose command, and you can view the PIM
information on VLANIF 15.
<Quidway> display pim interface vlanif 15 verbose
VPN-Instance: public net
Interface: Vlanif15, 10.0.0.15
PIM version: 2
PIM mode: Dense
PIM state: up
PIM DR: 10.0.0.15 (local)
PIM DR Priority (configured): 1
PIM neighbor count: 0
PIM hello interval: 30 s
PIM LAN delay (negotiated): 500 ms
PIM LAN delay (configured): 500 ms
PIM hello override interval (negotiated): 2500 ms
3 PIM-DM Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
3-28 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)
To Next Page
Loading...
