# Enable multicast on S9300-B and enable PIM-SM on each interface. The configurations of
other S9300s are similar to the configuration of S9300-B, and are not mentioned here.
[S9300-B] multicast routing-enable
[S9300-B] interface vlanif 100
[S9300-B-Vlanif100] pim sm
[S9300-B-Vlanif100] quit
[S9300-B] interface vlanif 200
[S9300-B-Vlanif200] pim sm
# Configure the domain boundary on VLANIF 100 of S9300-B.
[S9300-B-Vlanif100] pim bsr-boundary
[S9300-B-Vlanif100] quit
# Configure the domain boundary on VLANIF 200 and VLANIF 400 of S9300-C. Configure
the service boundary of BSR on VLANIF 400 of S9300-E. The configuration on S9300-E is
similar to the configuration on S9300-B, and is not mentioned here.
# Enable IGMP on the interface connecting S9300-D to the leaf network.
[S9300-D] interface vlanif 102
[S9300-D-Vlanif102] igmp enable
Step 4 Configure the C-BSR and C-RP.
# Create Loopback0, and then configure a C-BSR, and a C-RP on Loopback0 on S9300-B. The
configurations of S9300-C and S9300-E are similar to the configuration of S9300-B, and are
not mentioned here.
[S9300-B] interface loopback 0
[S9300-B-LoopBack0] ip address 1.1.1.1 255.255.255.255
[S9300-B-LoopBack0] pim sm
[S9300-B-LoopBack0] quit
[S9300-B] pim
[S9300-B-pim] c-bsr loopback 0
[S9300-B-pim] c-rp loopback 0
[S9300-B-pim] quit
Step 5 Configure MSDP peer relations.
# Configure the MSDP peer relation on S9300-B.
[S9300-B] msdp
[S9300-B-msdp] peer 192.168.2.2 connect-interface vlanif200
[S9300-B-msdp] quit
# Configure the MSDP peer relation on S9300-C.
[S9300-C] msdp
[S9300-C-msdp] peer 192.168.2.1 connect-interface vlanif200
[S9300-C-msdp] peer 192.168.4.2 connect-interface vlanif400
[S9300-C-msdp] quit
# Configure the MSDP peer relation on S9300-E.
[S9300-E] msdp
[S9300-E-msdp] peer 192.168.4.1 connect-interface vlanif400
[S9300-E-msdp] quit
Step 6 Verify the configuration.
# Run the display bgp peer command to view the BGP peer relation between S9300s. For
example, the following information shows the BGP peer relation on S9300-B and S9300-C:
<S9300-B> display bgp peer
BGP local router ID : 1.1.1.1
5 MSDP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
5-28 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)
To Next Page
Loading...
