Huawei Quidway S9300

Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
2.2.2.2 Up 00:10:17 ? 0 0
<S9300-D> display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
1.1.1.1 Up 00:10:18 ? 0 0
# Run the display pim routing-table command to view the PIM routing table on an S9300. In
the PIM-SM domain, multicast source S1 (10.110.5.100/24) sends multicast packets to multicast
group G (225.1.1.1). User 1 that joins G receives the multicast packets. Comparing information
about the PIM routing tables on S9300-C and S9300-D, you can find that S9300-C is the valid
RP. That is, S1 registers to S9300-C, and User 1 sends a Join message to S9300-C.
<S9300-C> display pim routing-table
VPN-Instance: public net
Total 1 (*, G) entry; 1 (S, G) entry
(*, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:28:49
Upstream interface: Register
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: vlanif104
Protocol: static, UpTime: 00:28:49, Expires: -
(10.110.5.1, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: SPT 2MSDP ACT
UpTime: 00:02:26
Upstream interface: vlanif101
Upstream neighbor: 10.110.1.2
RPF prime neighbor: 10.110.1.2
Downstream interface(s) information:
Total number of downstreams: 1
1: vlanif104
Protocol: pim-sm, UpTime: 00:02:26, Expires: -
<S9300-D> display pim routing-table
No output information is displayed.
# User 1 leaves group G, and multicast source S1 stops sending multicast packets to G. You can
run the reset multicast routing-table all and reset multicast forwarding-table all commands
to clear the multicast routing entries and multicast forwarding entries on S9300-C.
<S9300-C> reset multicast routing-table all
<S9300-C> reset multicast forwarding-table all
# User 2 joins group G, and multicast source S2 (10.110.6.100/24) sends multicast packets to
G. Comparing information about the PIM routing tables on S9300-C and S9300-D, you can find
that S9300-D is the valid RP. That is, S2 registers to S9300-D, and User 2 sends a Join message
to S9300-D.
<S9300-C> display pim routing-table
No output information is displayed.
5 MSDP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
5-44 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)