EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
<Quidway> system-view
[Quidway] igmp-snooping enable
Step 2 Create a VLAN and enable IGMP snooping in the VLAN.
# Create a VLAN and enable IGMP snooping in the VLAN.
[Quidway] vlan 100
[Quidway-vlan100] igmp-snooping enable
[Quidway-vlan100] quit
# Add GE 1/0/1 to the VLAN. The procedures for adding GE 1/0/2 and GE 2/0/0 to the VLAN
are similar and are not mentioned here.
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port hybrid tagged vlan 100
[Quidway-GigabitEthernet1/0/1] quit
Step 3 Set the version of IGMP snooping.
# Set the version of IGMP snooping to IGMPv3.
[Quidway] vlan 100
[Quidway-vlan100] igmp-snooping version 3
[Quidway-vlan100] quit
Step 4 Set the range of SSM group addresses.
[Quidway] acl number 2008
[Quidway-acl-basic-2008] rule 5 permit source 232.1.1.1 0.0.0.255
[Quidway-acl-basic-2008] quit
Step 5 Configure the SSM mapping function.
[Quidway] vlan 100
[Quidway] igmp-snooping ssm-policy 2008
[Quidway-vlan100] igmp-snooping ssm-mapping enable
[Quidway-vlan100] igmp-snooping ssm-mapping 232.1.1.1 24 10.1.1.1
Step 6 Verify the configuration.
# Run the display igmp-snooping vlan configuration command on the S9300 to view the
configuration of IGMP snooping in the VLAN.
[Quidway] display igmp-snooping vlan 100 configuration
IGMP Snooping Configuration for VLAN 100
igmp-snooping enable
igmp-snooping version 3
igmp-snooping ssm-mapping enable
igmp-snooping ssm-policy 2008
igmp-snooping ssm-mapping 232.1.1.0 255.255.255.0 10.1.1.1
# Add user hosts to multicast group 232.1.1.1.
# Run the display l2-multicast forwarding-table command to view the Layer 2 multicast
forwarding table.
[Quidway] display l2-multicast forwarding-table vlan 100
VLAN ID : 100, Forwarding Mode : IP
------------------------------------------------------------------------
(Source, Group) Interface Out-Vlan
------------------------------------------------------------------------
(10.1.1.1, 232.1.1.1) GigabitEthernet1/0/1 100
(10.1.1.1, 232.1.1.1) GigabitEthernet1/0/2 100
------------------------------------------------------------------------
Total Group(s): 1
----End
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 1 Layer 2 Multicast Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-37

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals