Huawei Quidway S9300 - Page 77

IGMP is enabled
Current IGMP version is 2
IGMP state: up
IGMP group policy: none
IGMP limit: -
Value of query interval for IGMP (negotiated): -
Value of query interval for IGMP (configured): 60 s
Value of other querier timeout for IGMP: 0 s
Value of maximum query response time for IGMP: 10 s
Querier for IGMP: 10.110.1.1 (this router)
# Run the display igmp routing-table command on S9300-A. You can check whether VLANIF
10 is added to the multicast group 225.1.1.1 statically. If the (*, 225.1.1.1) entry exists on
S9300-A, the downstream interface is VLANIF 10, and the protocol type is STATIC, you can
infer that VLANIF 10 is added to the multicast group 225.1.1.1 statically.
<S9300-A> display igmp routing-table
Routing table of VPN-Instance: public net
Total 1 entry
00001. (*, 225.1.1.1)
List of 1 downstream interface
Vlanif10 (10.110.1.1),
Protocol: STATIC
----End
Configuration Files
l Configuration file of S9300-A
#
sysname S9300-A
#
vlan batch 10 11
#
multicast routing-enable
#
interface vlanif 10
ip address 10.110.1.1 255.255.255.0
pim sm
igmp enable
igmp static-group 225.1.1.1
#
interface vlanif 11
ip address 192.168.1.1 255.255.255.0
pim sm
#
interface gigabitethernet 1/0/0
port hybrid tagged vlan 10
#
interface gigabitethernet 2/0/0
port hybrid tagged vlan 11
#
ospf 1
area 0.0.0.0
network 10.110.1.0 0.0.0.255
network 192.168.1.0 0.0.0.255
#
return
l Configuration file of S9300-B
#
sysname S9300-B
#
vlan batch 20 21
#
multicast routing-enable
#
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast 2 IGMP Configuration
Issue 01 (2009-07-28) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-23