Hurco winmax - Page 28

WinMax Lathe Conversational Part Programming v546CO Conversational Part Programming 2-5
• X (DIA) OR (RAD)—contains the X diameter or radius coordinate where the
turret should move.
This field is active when either Move Turret Home, Move to Position, or Move
All Home is selected in the WHERE field.
When the cursor is in this field, the STORE MACHINE POSITION F7 softkey
appears. Select this softkey to store the current machine position into the
field.
• Z—contains the Z coordinate where the turret should move.
This field is active when either Move Turret Home, Move to Position, or Move
All Home is selected in the WHERE field.
When the cursor is in this field, the STORE MACHINE POSITION F7 softkey
appears. Select this softkey to store the current machine position into the
field.
• W—contains the W coordinate where the turret should move. This field
appears on TMX, TMX MY, and TMX MYS Series machines.
This field is active when either Move to Position or Move All Home is selected
in the WHERE field.
When the cursor is in this field, the STORE MACHINE POSITION F7 softkey
appears. Select this softkey to store the current machine position into the
field.
• Y—contains the Y coordinate where the turret should move. This field appears
on TMX MY and TMX MYS Series machines.
This field is active when either Move to Position or Move All Home is selected
in the WHERE field.
When the cursor is in this field, the STORE MACHINE POSITION F7 softkey
appears. Select this softkey to store the current machine position into the
field.