EasyManuals Logo

Juniper EX2200 Hardware Guide

Juniper EX2200
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
Table 11: Port Edit Options (continued)
Your ActionFunctionField
To specify an IPv4 address:
1. Select the IPv4 address check box.
2. Type an IP address—for example: 10.10.10.10.
3. Enter the subnet mask or address prefix. For example,
24 bits represents 255.255.255.0.
4. Click OK.
To specify an IPv6 address:
1. Select the IPv6 address check box.
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334.
3. Enter the subnet mask or address prefix.
4. Click OK.
NOTE: IPv6 is not supported on EX2200 VC switches.
Applies the routed uplink role.
The interface family is set to inet, and
recommended CoS parameters are set for
schedulers and classifiers. See Table 12 on page 40
for more CoS information.
Routed Uplink
1. For this port role, you can select a VLAN member and
associate a native VLAN with the interface.
2. Click Details to view CLI commands for this role.
3. Click OK.
Applies the Layer 2 uplink role.
The interface family is set to ethernet-switching,
port mode is set to trunk, RSTP is enabled with the
point-to-point option, and trusted DHCP is
configured for port security.
Layer 2 Uplink
Specifies that no port role is configured for the
selected interface.
None
NOTE: For an EX8200 switch, dynamic ARP inspection and DHCP snooping parameters are not configured.
VLAN Options
Copyright © 2015, Juniper Networks, Inc.38
Network Interfaces for EX4300 Switches

Table of Contents

Other manuals for Juniper EX2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX2200 and is the answer not in the manual?

Juniper EX2200 Specifications

General IconGeneral
Throughput77 Mpps
MAC address table8000 entries
Jumbo frames supportYes
Number of VLANs1024
Networking standards-
Switch typeManaged
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports quantity48
StackableNo
Product colorBlack
Power consumption (typical)100 W
Operating altitude0 - 3048 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth254 mm
Width441 mm
Height43 mm
Weight3600 g

Related product manuals