Juniper EX4300

CHAPTER 11
Installing the Switch
•
Installing and Connecting an EX4300 Switch on page 165
•
Mounting an EX4300 Switch on page 166
•
Mounting an EX4300 Switch on Two Posts of a Rack or Cabinet on page 167
•
Mounting an EX4300 Switch on Four Posts of a Rack or Cabinet on page 169
•
Mounting an EX4300 Switch in a Recessed Position in a Rack or Cabinet on page 173
•
Mounting an EX4300 Switch on a Wall on page 173
•
Installing and Removing EX4300 Switch Hardware Components on page 176
Installing and Connecting an EX4300 Switch
To install and connect an EX4300 switch:
1. Follow instructions in “Unpacking an EX4300 Switch” on page 161.
2. Install a power supply if it is not preinstalled:
•
Installing an AC Power Supply in an EX4300 Switch on page 233
•
Installing a DC Power Supply in an EX4300 Switch on page 236
3. Install a fan module if it is not preinstalled; see “Installing a Fan Module in an EX4300
Switch” on page 229.
4. Mount the switch by following instructions appropriate for your site:
•
“Mounting an EX4300 Switch on Two Posts of a Rack or Cabinet” on page 167 (by
using the mounting brackets provided)
•
“Mounting an EX4300 Switch in a Recessed Positionin a Rack or Cabinet” on page 173
(by using the 2-in.-recess front brackets from the separately orderable four-post
rack-mount kit)
•
“Mounting an EX4300 Switch on Four Posts of a Rack or Cabinet” on page 169 (by
using the separately orderable four-post rack-mount kit)
•
“Mounting an EX4300 Switch on a Wall” on page 173 (by using the separately
orderable wall-mount kit)
5. Follow instructions in “Connecting Earth Ground to an EX Series Switch” on page 179.
165Copyright © 2017, Juniper Networks, Inc.