Juniper EX4300

•
The slot number (the member ID of the Virtual Chassis member)
•
Role of the switch in the Virtual Chassis (RE for master, BK for backup, and LC for line
card member)
•
Hostname
The LCD panel operates in boot mode during switch reboot. In the boot mode, the second
line of the LCD panel displays the key milestones in the switch boot process. The boot
mode does not have any menu options. After the boot process is complete, the LCD
panel automatically reverts to the Idle (IDLE) menu.
In idle mode, the second line of text on the LCD panel displays the mode of the network
ports’ Status LED and the number of chassis alarms. The number of alarms is updated
every second.
In status mode, the second line displays:
•
Status of the Virtual Chassis port (VCP)
•
Status of the power supplies
•
Status of the fan modules and the chassis temperature
•
Version of Junos OS for EX Series switches loaded on the switch
In maintenance mode, the second line displays one of the following options, which you
can use to configure and troubleshoot the switch:
•
System halt
•
System reboot
•
Load rescue
•
Request VC port
•
Factory default
•
EZSetup
LCD Panel Menus
The LCD panel has three menus: Idle, Status, and Maintenance. You can toggle between
the LCD panel menus by pressing the Menu button and navigatethrough the menu options
by pressing the Enter button.
Table 12 on page 30 describes the LCD panel menu options.
29Copyright © 2017, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions