Juniper EX4300

To enable a menu option:
[edit]
user@switch# delete chassis lcd-menu menu-item menu-option disable
Configuring a Custom Display Message
You can configure the second line of the LCD to display a custom message temporarily
for 5 minutes or permanently.
To display a custom message temporarily:
•
On an EX3200 switch, a standalone EX3300 switch, a standalone EX4200 switch, a
standalone EX4300 switch, a standalone EX4500 switch, a standalone EX4550 switch,
an EX6200 switch, an EX8200 switch, or an XRE200 External Routing Engine:
user@switch> set chassis display message message
•
On an EX3300, EX4200, EX4300, EX4500, or EX4550 switch in a Virtual Chassis
configuration:
user@switch> set chassis display message message fpc-slot slot-number
To display a custom message permanently:
•
On an EX3200 switch, a standalone EX3300 switch, a standalone EX4200 switch, a
standalone EX4300 switch, a standalone EX4500 switch, a standalone EX4550 switch,
an EX6200 switch, an EX8200 switch, or an XRE200 External Routing Engine:
user@switch> set chassis display message message permanent
•
On an EX3300, EX4200, EX4300, EX4500, or EX4550 switch in a Virtual Chassis
configuration:
user@switch> set chassis display message message fpc-slot slot-number permanent
NOTE: The buttons on the LCD panel are disabledwhen the LCD is configured
to display a custom message.
To disable the display of the custom message:
user@switch> clear chassis display message
You can view the custom message by issuing the show chassis lcd command.
Related
Documentation
• LCD Panel in EX3200 Switches
• LCD Panel in EX3300 Switches
• LCD Panel in EX4200 Switches
• LCD Panel in EX4300 Switches on page 27
Copyright © 2017, Juniper Networks, Inc.224
EX4300 Switch Hardware Guide