Krone Comprima V 180 - Page 216

17 Malfunction, cause and remedy
17.5 Faults of the electrics/electronics
216
Comprima V 180
Original Operating Instructions 150001053_00_en
Possible cause Remedy
FMI 7: The film stops when tying activated. The film tears off after starting or during tying.
The brake force release has
not been set correctly for the
feed process.
 Reduce the brake force release, refer to page149.
The cutting unit has fallen into
the film.
 Remove deposits from the cutting unit.
 Check the setting of the cutting unit.
 Check whether the cutting unit is engaged/clamped during
the feed process.
The cutting unit is not en-
gaged.
The cutting unit has been set
too deep.
The rotational speed is too
high.
 Check the rotational speed. It must not be higher than 540
rpm.
522022-
Net wrapping
Possible cause Remedy
FMI 7: The net is running, even though tying has not been started.
The net is pulled during bal-
ing.
 Adjust the wrapping material brake, refer to page150
The net is too far in the bale
channel.
 Check the net overhang.
 Check the sensorB61 "Tying 1 (passive)" and set the feed
position, refer to page136.
522022-
Chamber film wrapping
Possible cause Remedy
FMI 7: The film is running, even though tying has not been started.
The film overhang is too long.
 Check the film overhang. Ensure that it does not exceed
250mm.
 Adjust the brake force release during the feed process, refer
to page149.
522023-
Feed roller for net wrapping/chamber film wrapping
Possible cause Remedy
FMI 7: The speed of the feed roller is below the minimum when the net is pulled.
The machine is blocked.
 Remove the blockage.
The PTO shaft is rotating too
slowly.
 Set a higher rotational speed via the tractor on the PTO
shaft.
522024-
Net wrapping