LSI Corporation
- 386 -
12Gb/s MegaRAID SAS Software User Guide
March 2014
Appendix C: MegaCLI Commands to StorCLI Command Conversion
enableeug eghs
enablejbod Jbod
enblspindownunconfigdrvs ds
loadbalancemode loadbalancemode
maintainpdfailhistoryenbl maintainpdfailhistory
ncqdsply ncq
patrolreadrate prrate
perfmode perfmode
predfailpollinterval smartpollinterval
rebuildrate rebuildrate
reconrate migraterate
rstrhotspareoninsert restorehotspare
smartcpybkenbl copyback
spindowntime ds
spinupencdelay ds
spinupdelay spinupdelay
spinupencdrvcnt spinupdrivecount
ssdsmartcpybkenbl copyback
usediskactivityforlocate activityforlocate
usefdeonlyencrypt usefdeonlyencrypt
Set properties on the
selected controllers.
Megacli -AdpSetProp
<propertyname>-an|-a0,1,2|-aall
/cx set <property1>
The following properties can be set using this
command:
The following properties can be set using this command:
abortcconerror abortcconerror=<on|off>
alarmdsply alarm=<on|off| silence>
autodetectbackplanedsbl backplane=<value>
autoenhancedimportdsply foreignautoimport=<on|off>
batwarndsbl batterywarning=<on|off>
bgirate bgirate=<value>
bootwithpinnedcache bootwithpinnedcache=<on|off>
cachebypass cachebypass=<on|off>
ccrate ccrate=<value>
clusterenable
coercionmode coercion=<value>
copybackdsbl copyback=<on|off>
type=<smartssd|smarthdd|all>
defaultldpspolicy ds=<value>
defaultsnapshotspace
defaultviewspace
disableldpsinterval ds=<value>
disableldpstime ds=<value>
Description MegaCLI Command StorCLI Command
To Next Page
Loading...
