Lenze 8400 - Page 1051

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 1051
15 Parameter reference
15.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01073
C01074
C01075
Parameter | Name:
C01073 | L_DFSET_1: Adjustment
Data type: UNSIGNED_8
Index: 23502
d
= 5BCE
h
From version 11.00.00
Setting range (min. hex value | max. hex value)
0x00 0xFF
Value is bit-coded: Info
Bit 0 Setpoint angle without gearbox
factor
0 ≡ Evaluation of the setpoint angle with gearbox factor
1 ≡ Evaluation of the setpoint angle without gearbox
factor
Bit 1 Angle correction with polynomial 0 ≡ Angle correction without downstream polynomial
1 ≡ Angle correction with downstream polynomial
Bit 2 External angle correction 0 ≡ Internal angle correction
1 ≡ External angle correction
• From version 13.00.00
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Subcodes Lenze setting Info
C01073/1 0x02 L_DFSET_1
: Adjustment
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C01074 | L_DFSET_1: Zero pulse divider
Data type: UNSIGNED_16
Index: 23501
d
= 5BCD
h
From version 11.00.00
Setting range (min. value | unit | max. value)
0 16384
Subcodes Lenze setting Info
C01074/1 0 L_DFSET_1: Divider for actual value zero pulse
C01074/2 0 L_DFSET_1
: Divider for setpoint zero pulse
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01075 | L_DFSET_1: Synchronisation mode
Data type: UNSIGNED_8
Index: 23500
d
= 5BCC
h
From version 11.00.00