Lenze 8400 - Page 1153

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 1153
15 Parameter reference
15.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02870
C02871
C02872
C02873
Parameter | Name:
C02870 | PLI without motion: Optimisation factor
Data type: INTEGER_16
Index: 21705
d
= 54C9
h
From version 11.00.00
Pole position identification without motion
Display range (min. value | unit | max. value)
0.00 % 300.00
Subcodes Info
C02870/1 PLI without motion: Optimisation factor
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C02871 | PLI without motion: Running time
Data type: INTEGER_16
Index: 21704
d
= 54C8
h
From version 11.00.00
Pole position identification without motion
Display range (min. value | unit | max. value)
0.00 ms 300.00
Subcodes Info
C02871/1 PLI without motion: Running time
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C02872 | PLI without motion: Adaptation of time duration
Data type: INTEGER_8
Index: 21703
d
= 54C7
h
From version 11.00.00
Pole position identification without motion
Setting range (min. value | unit | max. value)
-10 10
Subcodes Lenze setting Info
C02872/1 0 PLI without motion: Adaptation of time duration
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C02873 | PLI without motion: Ident. el. rotor displ. angle
Data type: INTEGER_16
Index: 21702
d
= 54C6
h
From version 11.00.00
Pole position identification without motion
Display range (min. value | unit | max. value)
0 ° 360
Subcodes Info
C02873/1 PLI without motion: Ident. el. rotor displ. angle
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1