Lenze 8400 - Page 1154

15 Parameter reference
15.2 Parameter list
1154
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02874
C02875
Parameter | Name:
C02874 | PLI without motion
Data type: UNSIGNED_16
Index: 21701
d
= 54C5
h
From version 11.00.00
Pole position identification without motion
Setting range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded:
Bit 0 for SLPSM with controller enable
Bit 1 Reserved
Bit 2 Reserved
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Subcodes Lenze setting Info
C02874/1 0x0001 PLI without motion
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C02875 | PLI without motion: Adaptation of ident angle
Data type: INTEGER_8
Index: 21700
d
= 54C4
h
From version 11.00.00
Pole position identification without motion
Setting range (min. value | unit | max. value)
-100 ° 100
Subcodes Lenze setting Info
C02875/1 0 ° PLI without motion: Adaptation of ident angle
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1