Lenze 8400 - Page 631

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 631
9 Diagnostics & error management
9.4 Drive diagnostics via keypad/bus system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Identification data
The parameters listed in the following table belong to the Identification category of the »Engineer«
parameter list and the keypad and serve to display the identification data of the inverter:
C00177/6 STO counter after power-on
C00177/7 DigIn CINH counter after power-on
C00177/8 IMP counter after power-on
C00178 Time the inverter was enabled (elapsed-hour meter)
C00179 Power-up time (power-on time meter)
C00180/1 Runtime - control card
C00180/2 Running time - heatsink fan
C00180/3 Running time - internal fan
Parameters Display
C00099 Firmware version (as a string)
C00199/1
Device name
Automatic acceptance of the device name in the »Engineer«
C00200 Firmware product type
C00201/1...6 Firmware of the control card and the power section
C00203/1...9 Product type code of the individual device components
C00204/1...9 Serial numbers of the individual device components
Parameters Display