Lenze 8400 - Page 914

15 Parameter reference
15.2 Parameter list
914
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00508
Bit 1 Parameter write protection 1 ≡ The currently used communication channel cannot
be used to write into write/read parameters.
Password protection
Bit 2 Parameter read protection 1 ≡ The currently used communication channel cannot
be used to read write/read parameters.
Password protection
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Memory module binding on 1 ≡ Device personalisation is active. All write/read
actions between inverter and memory module are only
executed if both components have the same binding ID.
Device personalisation
Subcodes Info
C00507/1 Password protection - all communication channels
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C00507 | Current password protection
Data type: UNSIGNED_16
Index: 24068
d
= 5E04
h
Parameter | Name:
C00508 | PW protection config X6(DIAG)
Data type: UNSIGNED_16
Index: 24067
d
= 5E03
h
From version 15.00.00
Configuration of the password protection for parameter access via diagnostic interface X6 ("DIAG")
Individual password protection for single communication channels
Setting range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Reserved
Bit 1 Parameter write protection The diagnostics interface X6 cannot be used to write into
write/read parameters.
Bit 2 Parameter read protection The diagnostics interface X6 cannot be used to read
write/read parameters.
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved