Lenze 8400 - Page 915

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 915
15 Parameter reference
15.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00509
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Subcodes Lenze setting Info
C00508/1 0x0006 PW protection config X6(DIAG)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C00508 | PW protection config X6(DIAG)
Data type: UNSIGNED_16
Index: 24067
d
= 5E03
h
Parameter | Name:
C00509 | PW protection config X1(CAN)
Data type: UNSIGNED_16
Index: 24066
d
= 5E02
h
From version 15.00.00
Configuration of the password protection for parameter access via CANopen interface X1 ("CAN on board")
Individual password protection for single communication channels
Setting range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Reserved
Bit 1 Parameter write protection The CANopen interface X1 cannot be used to write into
write/read parameters.
Bit 2 Parameter read protection The CANopen interface X1 cannot be used to read write/
read parameters.
Bit 3 Reserved
Bit 4 Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
Subcodes Lenze setting Info
C00509/1 0x0006 PW protection config X1 (CAN)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT