Lexmark MX610 - Connecting the Printer Using the Wireless Setup Wizard

9 Close the front door.
10 From the printer control panel, select Continue to clear the message and continue printing.
200 paper jam messages
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to “Sensor (input) static jam service check” on
page 55.
200.02 Input sensor covered too quickly. Go to “Sensor (input) early/late arriving service
check” on page 56.
200.03 Media did not reach input sensor from MPF. Go to “Sensor (input) early/late arriving service
check” on page 56.
200.05 Input sensor covered too long. Go to “Sensor (input) early/late arriving service
check” on page 56.
200.07 Input sensor failed to become uncovered from sheet
ahead.
Go to “Sensor (input) early/late arriving service
check” on page 56.
200.08 Page arrive at input senor at unexpected time. Go to “Sensor (input) early/late arriving service
check” on page 56.
200.09 Printhead did not receive proper motor feedback to
start laser servo.
Go to “Sensor (input) image jam service check” on
page 57.
200.10 Printhead motor not locked when media reaches the
input sensor.
Go to “Sensor (input) image jam service check” on
page 57.
200.11 Printhead motor fell out of lock after page reaches the
input sensor.
Go to “Sensor (input) image jam service check” on
page 57.
200.12 Printhead was not ready for media. Go to “Sensor (input) image jam service check” on
page 57.
200.13 Media at input sensor is not the next media to be
imaged.
Go to “Sensor (input) image jam service check” on
page 57.
200.14 Media reached the input sensor before EP was ready. Go to “Sensor (input) image jam service check” on
page 57.
200.15 Image data did not start on time. Go to “Sensor (input) image jam service check” on
page 57.
200.16 Fuser motor stalled. Go to “Main drive motor control jam service check”
on page 58.
200.19 Page that was successfully picked from option tray
never reached the input sensor.
Go to “Sensor (input) early/late arriving service
check” on page 56.
200.21 No response from paper port driver while waiting for
the source to deactivate the Input Source Ready flag
to indicate it has initiated picking.
Go to “Sensor (input) early/late arriving service
check” on page 56.
200.23 Laser servo never started due to potential conflict
with the transfer servo.
Go to “Sensor (input) image jam service check” on
page 57.
7016
Diagnostic information
54