Lexmark MX610 - Page 55

Error code Description Action
200.24 Measured gap at input sensor too small to meet video
delivery requirements. (Not enough time since prior
image finished to start new image).
Go to “Sensor (input) image jam service check” on
page 57.
200.29 Printhead drive control out of range due to an
external event beyond what the control is designed
to handle.
Go to “Sensor (input) image jam service check” on
page 57.
200.30 Invalid printhead NVRAM. Go to “Sensor (input) image jam service check” on
page 57.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
Go to “Sensor (input) early/late arriving service
check” on page 56.
200.32 Detected cover switch bounce. Go to “Sensor (input) early/late arriving service
check” on page 56.
200.33 Input sensor covered too quickly. Go to “Sensor (input) early/late arriving service
check” on page 56.
200.38 Interpage servo gap smaller than expected for galvo
offset target evaluation.
Go to “Sensor (input) early/late arriving service
check” on page 56.
200.42 Rogue sheet at ACM sensor while flushing the paper
path prior to declaring Tray 1 source empty.
Go to “Sensor (input) early/late arriving service
check” on page 56.
200.44 Page from Tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple pick
attempts. Page did make it out of the tray at least as
far as the ACM sensor.
Go to “Sensor (input) early/late arriving service
check” on page 56.
200.45 During warm up flush, sheet detected too long over
input sensor.
Go to “Sensor (input) early/late arriving service
check” on page 56.
Sensor (input) static jam service check
Action Yes No
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Go to step 2. Clear the paper path of
any media fragments.
Step 2
Check the jam access cover if it is blocking the input sensor.
Is it blocking the input sensor?
Replace the jam access
cover. See “Jam access
cover removal” on
page 290.
Go to step 3.
Step 3
Check the input sensor cable for proper connection.
Is it properly connected?
Go to step 4. Reseat the cable.
7016
Diagnostic information
55