Note: Make sure all paper fragments are removed.
4 Close the front and rear door.
5 From the printer control panel, select Done to clear the message and continue printing.
202 paper jam messages
Error code Description Action
202.01 Exit sensor is covered during warm up. Go to “Sensor (fuser exit) jam service check” on
page 61.
202.03 Media did not reach the fuser exit sensor. Go to “Sensor (fuser exit) jam service check” on
page 61.
202.05 Fuser exit sensor covered too long by the current
sheet.
Go to “Sensor (fuser exit) jam service check” on
page 61.
202.07 Fuser exit sensor covered too long by the previous
sheet.
Go to “Sensor (fuser exit) jam service check” on
page 61.
202.13 Restart attempted after an internal jam without cover
open. Close event. Likely that the jam was not actually
cleared.
Go to “Sensor (fuser exit) jam service check” on
page 61.
202.14 Expected banner sheet ( assumed wide ) not detected
by narrow media sensor, possible accordion jam,
unsupported narrow banner media, or missing signal.
Go to “Sensor (fuser exit) jam service check” on
page 61.
202.16 Page at fuser nip before fuser started ramping toward
desired. Indicates code may be receiving more hall
interrupts than intended.
Go to “Sensor (fuser exit) jam service check” on
page 61.
202.17 Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser earlier
than expected, so it was probably staged.
Go to “Sensor (fuser exit) jam service check” on
page 61.
202.22 Cartridge Motor - Motor Underspeed Error. Motor
made it to closed loop steady state, but then detected
speed was below threshold.
Go to “Sensor (fuser exit) jam service check” on
page 61.
7016
Diagnostic information
60
To Next Page
Loading...
