Lexmark MX610 - Page 61

Error code Description Action
202.28 Exit sensor bounce issue. Go to “Sensor (fuser exit) jam service check” on
page 61.
202.32 The sheet is too long to be duplexed. The blow
through is enabled.
Go to “Duplex service check” on page 64.
202.36 Long paper or shingled multi feed stopped before
sending to duplex.
Go to “Duplex service check” on page 64.
202.43 During warm up flush, media that passed the input
sensor failed to reach the exit sensor.
Go to “Sensor (fuser exit) jam service check” on
page 61.
202.45 During warm up flush, sheet detected too long over
exit sensor.
Go to “Sensor (fuser exit) jam service check” on
page 61.
Sensor (fuser exit) jam service check
Action Yes No
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Go to step 2. Clear the paper path of
any media fragments.
Step 2
Check the fuser exit sensor cable JEXIT1 for proper connection.
Is it properly connected?
Go to step 3. Reseat the cable.
Step 3
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Exit
Does the sensor state on the control panel display change when it is
toggled?
Go to step 4. Replace the fuser. See
“Fuser removal” on
page 320.
Step 4
Check the fuser gears and rollers for damage.
Are they free of damage?
Go to step 5. Replace the fuser. See
“Fuser removal” on
page 320.
Step 5
Does the error remain?
Contact the next level
of support.
The problem is solved.
7016
Diagnostic information
61