LS Industrial Systems XGT Series - Parameter and Operation Data Setting

Chapter 8 Program
8-47
8.2.4 Parameter and Operation Data Setting
(1) Parameter Setting
(a) This is the condition for Parameter Setting Command
This is the condition for Basic Parameter Setting Command (APM_SBP)
(b) This is the condition for Home/Manual Parameter Setting Command
This is the condition for Home/Manual Parameter Setting Command (APM_SHP)
(a) Condition for Parameter Setting Command
(b) Condition for Home/Manual
Parameter setting
(c) Operating state by axis
(e) Address of Positioning Module
(d) Error state for each axis
(e) Address of Positioning Module
(f) Axis of command execution
(g) List of Changing Parameter
(h) Value of Changing Parameter
(f) Axis of command execution
(g) List of Changing Parameter
(h) Value of Changing Parameter