Chapter 10 Positioning Monitoring Package
10-1
Chapter 10 Positioning Monitoring Package
10.1 Positioning Monitoring Package
You can monitor the status of XGB PLC positioning module and carry out test operation without the program by
changing the parameters and operation data if you use the XGB monitoring package.
10.1.1 Introduction of Positioning Monitoring Package
• You can easily and conveniently monitor the current positioning operation or change the parameter or operation
data by using the following positioning monitoring package with XGB PLC connected to XG5000.
• If you use the positioning monitoring package, you can easily carry out test operation without the program, adjust
the parameter and operation data, and permanently save it in PLC after the adjustment.
• XGB positioning monitoring package for XGB positioning module is available with over XG5000 V3.1 and it is
carried out in the following sequence.
(1) Opening the Monitoring Package
• Select ‘Monitoring’ Æ ‘Special Module Monitoring’ with XGB PLC connected to XG5000, the special module
monitoring display is invoked as follows.
(If XGB is not connected to XG5000, ‘Special Module Monitoring’ is inactivated in the ‘Monitoring’ menu. Thus
make sure that XGB is connected to XG5000 before using positioning monitoring.)
• When you want to carry out the positioning monitoring package, double click on the positioning module or
select the positioning module, and then click on the ‘Monitoring’ button at the bottom. And the positioning
monitoring package is started as follows.
To Next Page
Loading...
